Parlor Vent Free Fireplace | FIREPLACE INSTALLATION |
SECURE HEATER TO FLOOR OR HEARTH
Note: Clearance requirements as detailed in “Clearances and Height Requirements” section on Page 10 of this manual, must be met before securing the heater in place.
1.Open the control access door.
2.Remove five (5) screws holding engine base to unit. Figure 9
3.Slide engine assembly forward out of unit.
4.Secure the firebox with two (2) anchoring screws (3/16" x 1Z\v" length) supplied with fireplace. Figure 10
Install ARCHED BRICK LINER
1.Remove arched brick liner from packaging.
2.Remove two (2) screws holding light fixture to bracket attached to burners. Figure 11
3.Carefully lay light fixture onto burner top.
4.Carefully pick up brick liner with two hands and tilt top of liner away from unit. Figure 12
5.Place bottom of liner into firebox behind burner and pilot assembly. Be careful not to bend or break fuel line to pilot.
6.Once bottom of liner is in place, gently push top in place.
7.Gently center liner in firebox.
8.Replace light fixture to bracket.
Installation complete.
NOTE: The arched brick liner should be leaning forward until decorative face is in place. Refer to Page 30.
Screws
Engine Assembly
FP2560
Light
Fixture
Screws
Figure 9 -
Remove Engine Assembly
Anchor Screws |
|
3/16" x 1Z\v" | FP2561 |
Figure 10 -
Secure Heater to Floor or Hearth
FP2554
Screws
Figure 11 -
Place Light Fixture on Burner Top
Figure 12 -
Firebrick Panel
FP2555
12 | 90D0093 |
