Chapter 2 Switch Installation

Installing the Switch

Verifying Boot Fast

When you power on the switch, it automatically begins a boot fast sequence. The System LED blinks green as the Cisco IOS software image loads. If the boot fast sequence fails, the System LED turns red.

Note Boot fast failures are usually fatal. Call Cisco TAC immediately if your switch does not complete boot fast successfully. See the “Obtaining Documentation, Obtaining Support, and Security Guidelines” section on page -viii.

Note You can disable the boot fast and run POST by using the Cisco IOS CLI. See the Cisco IE 2000 Switch Software Configuration Guide and the Cisco IE 2000 Switch Command Reference for more information.

Disconnecting Power

To disconnect power after successfully running boot fast, follow these steps:

Step 1 Turn off power to the switch.

Step 2 Disconnect the cables.

Installing the Switch

This section describes how to install the switch:

Installing the Switch on a DIN Rail

Removing the Switch from a DIN Rail

Warning This equipment is supplied as “open type” equipment. It must be mounted within an enclosure that is suitably designed for those specific environmental conditions that will be present and appropriately designed to prevent personal injury resulting from accessibility to live parts. The interior of the enclosure must be accessible only by the use of a tool.

The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards. Statement 1063

Warning When used in a Class I, Division 2, hazardous location, this equipment must be mounted in a suitable enclosure with proper wiring method, for all power, input and output wiring, that complies with the governing electrical codes and in accordance with the authority having jurisdiction over Class I, Division 2 installations. Statement 1066

 

 

Cisco IE 2000 Switch Hardware Installation Guide

 

 

 

 

 

 

OL-25818-04

 

 

2-31

 

 

 

 

 

Page 61
Image 61
Cisco Systems IE20004TSL, IE20004TSB, IE200016TCB manual Installing the Switch, Verifying Boot Fast, Disconnecting Power