Chapter 2 Switch Installation

Connecting to a Console Port

Figure 2-2 Removing the Flash Memory Card from the Switch

16TC

0.5-3.0A

331949

Step 2 Install or remove the card:

To install a card, slide it into the slot, and press it in until it clicks in place. The card is keyed so that you cannot insert it the wrong way.

To remove the card, push it in until it releases for it to pop out. Place it in an antistatic bag to protect it from static discharge.

Step 3 After the card is installed, close the guard door and fasten the captive screw using a Phillips screwdriver to keep the door in place.

Connecting to a Console Port

You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access the CLI:

RJ-45 Console Port

USB Mini-Type B Console Port

Warning If you connect or disconnect the console cable with power applied to the switch or any device on the network, an electrical arc can occur. This could cause an explosion in hazardous location installations. Be sure that power is removed or the area is nonhazardous before proceeding. Statement 1080

Cisco IE 2000 Switch Hardware Installation Guide

 

OL-25818-04

2-9

 

 

 

Page 39
Image 39
Cisco Systems IE20004TSB, IE20004TSL manual Connecting to a Console Port, RJ-45 Console Port USB Mini-Type B Console Port