Monitor Audio BRW-10 warranty Power Mode Switch with On-Auto-OffFacility, Warning Information

6.Power Mode Switch with On-Auto-Off Facility

The Power Mode Switch has three positions: ‘On’–‘Auto’–‘Off’. When the switch is in the ‘Off’ position the subwoofer will not function. In the ‘Auto’ position the subwoofer will automatically switch on when an input signal is received. It will remain on. If no signal is received for around 15-20 minutes, the BRW-10 will then switch into standby mode until a signal is received once more. With the switch in the ‘On’ position, the subwoofer is permanently switched on under all conditions.

7.Warning Information

The following warning symbols are found on the amp panel. The meanings are:

This lightening flash with an arrow head symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to the persons.

Warning: To reduce the risk of electric shock, do not remove cover (or back) no user-serviceable parts inside. Refer servicing to qualified service personnel

This exclamation point within an equilateral triangle is intended to alert the user to presence of important operating maintenance (servicing) instructions in the literature accompanying the appliance

8.Mains Power Switch

The Mains Power Switch should be switched to the ‘Off’ position when the BRW- 10 will not be used for extended periods. The switch must be in the ‘On’ position for the sub-woofer to function.

WARNING: Due to the mains switch being located on the rear panel, the apparatus must be located in the open area with no obstructions to access the mains switch.

9.Mains Voltage Selector

This is factory set to your country’s mains voltage specification. Do not attempt to adjust this as this may lead to permanent damage to the product and even the risk of fire.

10.IEC Mains Power Connector/ Fuse Location

The BRW-10 is supplied with a two-pin mains input socket for connection to the mains supply. Use ONLY the appropriate IEC mains lead provided with the product. Also fitted is an external mains fuse. If a fuse blows during operation a spare fuse is provided within the fuse holder for replacement. If you wish to change the fuse, you can do this by removing the IEC mains lead and carefully levering out the original fuse from its holder below the IEC mains input socket (10a). If the fuse blows again it is advisable to seek help from an authorised service agent. DO NOT attempt to re-fit a further fuse as this could result in serious damage to the amplifier unit.

8

© Monitor Audio 2006 BRW-10 Rev4