Attaching the Tilting Vertical Adjustment Bars to the TV DO NOT lay your TV face down when attaching the Tilting
Vertical Adjustment Bars. This can cause permanent damage
to your screen. Lean it against a wall or other solid surface so
it remains vertically upright.
Your TV should be unplugged before threading any bolt
or screw into the back panel.
Your mounting system features 12 sets of screws of varying diameter
and length. Before attaching the adjustment bars to your display, determine
which screw set is correct for your display.
TVs with flat backs use a shorter screw without a spacer. TVs with curved backs
or recessed inserts may require a longer screw with a spacer between the TV
and adjustment bars. Smaller M4, M5 or M6 screws require a square washer
(supplied) between the adjustment bar and each screw.
Locate the threaded inserts on your TV’s back panel. Thread a screw
from the set into one of the inserts to ensure it is the correct choice.
Thread screws through the adjustment bars into the TV inserts with the
appropriate spacer and washer set. Make sure to install each adjustment
bar so its Pull ‘n’ Twist™ handle faces the outer edge of the TV.
With a Phillips screwdriver, tighten the screws so the adjustment bars are
firmly attached to the TV.
DO NOT over tighten screws. Thread screws carefully by hand before
tightening. If you feel any resistance, remove the screw immediately.
1)
2)
3)
12