Onkyo TX-NR1009 Adjusting the Volume for Zones, Muting Zones, Operating on the remote controller

Adjusting the Volume for Zones

■Operating on the remote controller

1	press ZONE repeatedly.
2	Use VOL q/wto adjust the volume.

■Operating on the AV receiver

1	Press ZONE 2 or ZONE 3 (the Z2/3 indicator on
	the display flash).
2	Use MASTER VOLUME control within 8 seconds
	to adjust the volume.

If your Zone 2/3 speakers are connected to a receiver or integrated amp in Zone 2/3, use its volume control to adjust the volume.

Muting Zones

■Operating on the remote controller

1 Press ZONE repeatedly, and then press MUTING.

Tip

•To unmute, press ZONE followed by MUTING again. Zones can also be unmuted by adjusting the volume.

Adjusting the Tone and Balance of Zone 2

1	On the AV receiver, press ZONE 2.
2	Press the AV receiver’s TONE repeatedly to select
	“Bass”, “Treble” or “Balance”.
3	Use –/+to adjust the bass, treble or balance.

• You can boost or cut the bass or treble from –10 dB to +10 dB in 2 dB steps.

• You can adjust the balance from 0 in the center to +10 dB to the right or +10 dB to the left in 2 dB steps.

Note

•Only analog input sources are output by the ZONE 2/3 PRE/LINE OUT and FRONT WIDE/ZONE 2 L/R, FRONT HIGH/ZONE 3 L/R terminals. Digital input sources are not output. If no sound is heard when an input source is selected, verify that the source is connected to an analog input.

•While Zone 2/3 is on, ufunctions will not work.

•You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room. Namely, if you have selected an FM station for the main room, that station will also be output in Zone 2/3.

•When you have selected NET or USB as the input selector, the last selector selected will be set for Main room, Zone 2, and Zone 3.

•When Zone 2/3 is activated and its input selector is selected, the power consumption of standby mode slightly increases.

•When setting the AV receiver to standby mode while Zone 2/3 is active, the Z2/3 indicator is dimly lit.

•Activating Zones in the main room when the listening mode is set to Pure Audio will automatically switch it to Direct.

•When Powered Zone 3 is used, playback in the main room is reduced to 5.1 channels.

•The Zone 2 volume, tone, and balance function have no effect on ZONE 2 PRE/LINE OUT when the “Zone2 Out” setting is set to “Fixed” (➔ page 60).

•The Zone 3 volume function has no effect on ZONE 3 PRE/LINE OUT when the “Zone3 Out” setting is set to “Fixed” (➔ page 60).

•Even if you repeatedly press the remote controller’s ZONE to select zones, the last zone selection will be retained once you have switched to other components by pressing other REMOTE MODE after pressing ZONE.

En

68