Onkyo TX-NR1009 Controlling Zone 2/3 Components, 12V Trigger Out, Operating on the AV receiver

12V Trigger Out

When Zone 2/3 is turned on, the output from the 12V TRIGGER OUT jack goes high (+12 V and max. 150 mA for Zone 2, +12 V and max. 25 mA for Zone 3). Connecting this jack to a 12-volt trigger input on a component in Zone 2/3 will make that component turn on or off as the AV receiver turns on or off the Zone 2/3.

■Operating on the remote controller

To control Zone 2/3, you must press the remote controller’s ZONE first.

ZONE turns red while Zone 2 is on, and green while Zone 3 is on.

8RECEIVER

ZONE

Controlling Zone 2/3 Components

■Operating on the AV receiver

Input selector buttons

MASTER VOLUME

Input selector buttons

MUTING

VOLq/w

		1 Press ZONE repeatedly, then point the remote
		controller at the AV receiver and press
		8RECEIVER.
		Zone 2/3 turns on, the Z2/3 indicator lights on the
ZONE 3		display.
ZONE 2	OFF	Tip
1 To turn on Zone 2/3 and select an input source,		• The corresponding trigger output goes high (+12 V).
		2 To select an input source for Zone 2/3, press ZONE
press ZONE 2 or ZONE 3 followed by an input
selector button within 8 seconds.		repeatedly, followed by INPUT SELECTOR.

Zone 2/3 turns on, the Z2/3 indicator lights on the

To select AM or FM, press the TUNER input selector

display.

and ZONE repeatedly.

Tip

• The corresponding trigger output goes high (+12 V).

To select AM or FM, press TUNER input selector and ZONE 2 or ZONE 3 repeatedly.

To select the same source as the main room’s, press ZONE 2 or ZONE 3 twice. “Z2 Selector: Source” or “Zone 3 Selector: Source” appears on the display.

Note

•You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room.

3 To turn off Zone 2/3, press ZONE repeatedly, followed by 8RECEIVER.

Tip

• The corresponding trigger output goes low (0 volts).

To turn off Zone 2/3, press ZONE 2 or ZONE 3.

The Z2/3 indicator on the display flash. Press OFF.

The zone is turned off.

Tip

• The corresponding trigger output goes low (0 volts).

En

67