Onkyo TX-NR1009 Remote Controller Setup, Lock Setup, Using the Audio Settings, Remote Mode Setup

Remote Controller Setup

Main menu Remote Controller Setup

Remote Mode Setup

See “Looking up for Remote Control Code” (➔ page 73).

Activities Setup

Via onscreen menu, you can specify what actions will be taken by the Easy macro command in the Easy macro mode (➔ page 43).

First, select the ACTIVITIES (MY MOVIE, MY TV, or MY MUSIC) that you want to configure.

■Source

`BD/DVD, VCR/DVR, CBL/SAT, GAME, PC, AUX, TUNER, TV/CD, PHONO, PORT, NET,

USB

With this setting, you can choose the target input source of the Easy macro.

■TV Power On

`Enable

`Disable

With this setting, you can specify whether or not to turn on your TV.

■Source Power On

`Enable

`Disable

With this setting, you can specify whether or not to turn on the source component.

■Receiver Power On

`Enable

`Disable

With this setting, you can specify whether or not to turn on the AV receiver.

■Receiver Source Change

`Enable

`Disable

With this setting, you can specify whether or not to change the input source.

■Source Play

`Enable

`Disable

With this setting, you can specify whether or not to start playback.

Lock Setup

With this preference, you can protect your settings by locking the setup menus.

Main menu Lock Setup

■Setup

`Locked

`Unlocked

When “Locked” is selected, the setup menus will be locked and you cannot change any setting.

Using the Audio Settings

You can change various audio settings from the Home menu (➔ page 40).

1	Press RECEIVER followed by HOME.
2	Use q/wand ENTER to select “Audio”, and then
	use q/w/e/rto make the desired selection.

Note

•These settings are not available in either of the following cases:

–a pair of headphones is connected.

–the “Audio TV Out” setting is set to “On” (➔ page 61).

–“HDMI Control(RIHD)” is set to “On” (➔ page 60) and you’re listening through your TV speakers.

Tone Control Settings

■Bass

`–10dBto 0dB to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output from the front speakers.

■Treble

`–10dBto 0dB to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output from the front speakers.

You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode is selected.

Operating on the AV receiver

1	Press TONE repeatedly to select either “Bass” or
	“Treble”.
2	Use + and – to adjust.

Note

•This setting is not available when the multichannel analog input is selected.

En

63