7
Insert downrod into yoke on top of fan body. Align the hole in the down- rod with hole in the yoke. Insert pin through the yoke and downrod until the point appears on the other side. Install the keeper.
10
Carefully lift fan assembly onto mounting brack- et. Rotate fan so that the notch on the ball engages the ridge in the mounting bracket. This will allow
8
Tighen set screws and nuts to secure downrod in yoke.
|
|
|
| Safety cable installation |
| 11 |
|
| |
| Safety Cable | |||
|
| Lag Screw | ||
Lag Screw
Safety Cable
Washer
Lock Washer
For Canadian installation and for USA fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
9
Check the fan motor for shipping sta- bilizer and remove if present.
12
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
13
For pullchain controls, follow diagram above. Make sure that all exposed wiring is secured inside wire nuts. Note: Wires from house may vary in color and may not include ground wire. After wiring is conplete, gently push wires into junction box with wire nuts pointing upward. Refer to point 3 of safety tips.
14
Fan Switch
Light Switch
Wall
Control
For control of fan and optional light from wall location, follow diagram above. NOTE: A profes- sional electrician is recommended for this type of installation.
15
Raise the canopy up and align the two holes in the canopy with the two holes in the hanger bracket. Twist into place. Secure with two screws provided.
16
Attach blade brackets to blades using the blade bracket screws and wash- ers provided.
17
Attach blade assembly to motor using the motor screws and washers provided. Tighten screws securely.
18
Remove 1 screw and loosen 2 screws.
