Pioneer DVR-543H-S, DVR-540H-S Additional information Condensation, Hints on installation

15Additional information

Condensation

Condensation may form inside the recorder if it is brought into a warm room from outside, or if the temperature of the room rises quickly. Although the condensation won’t damage the recorder, it may temporarily impair its performance. For this reason you should leave it to adjust to the warmer temperature for about an hour before switching on and using.

Hints on installation

We want you to enjoy using this unit for years to come, so please bear in mind the following points when choosing a suitable location for it:

Do...

Use in a well-ventilated room.

Place on a solid, flat, level surface, such as a table, shelf or stereo rack.

Don’t...

Use in a place exposed to high temperatures or humidity, including near radiators and other heat-generating appliances.

Place on a window sill or other place where the recorder will be exposed to direct sunlight.

Use in a dusty or damp environment or in a room where it will be exposed to excessive cigarette smoke.

Place directly on top of an amplifier, or other component in your stereo system that becomes hot in use.

Use near a television or monitor as you may experience interference—especially if the television uses an indoor antenna.

132

Use in a kitchen or other room where the recorder may be exposed to smoke or steam.

Use on a thick rug or carpet, or cover with cloth—this may prevent proper cooling of the unit.

Place on an unstable surface, or one that is not large enough to support all four of the unit’s feet.

Moving the recorder

If you need to move the recorder, first remove the disc, if there’s one loaded, and close the disc tray. Next, press STANDBY/ ON to switch the power to standby, checking that the POWER OFF indication in the display goes off. Wait at least two minutes. Lastly, disconnect the power cord. Never lift or move the unit during playback or recording—discs rotate at a high speed and may be damaged.

Resetting the recorder

If you need to, you can reset the recorder to all its factory settings.

1Make sure that the recorder is on.

2Using the front panel controls, press

and hold STOP and press STANDBY/ ON.

The recorder turns off with all settings reset.

En