Pioneer DVR-543H-S Additional information, ProblemRemedy, No sound or sound is distorted

15Additional information

ProblemRemedy

Remote control does • If you connected this recorder to another Pioneer product using the

not workCONTROL IN jack, point the remote control at the other component to use (page 16).

•Set the remote control to the same ID number as the recorder (page 117). (When the batteries run down, the remote mode is automatically reset to Recorder1.)

•Use the remote within its operating range (page 8).

•Replace the batteries (page 8).

No sound or sound is distorted

•Make sure that the amp/receiver or TV is set to the correct input and the volume turned up.

•There is no sound when the picture is paused, or during scanning or slow motion play. Press PLAY to resume regular playback.

•DTS discs can only be played if this recorder is connected to a DTS decoder or DTS compatible amp/receiver. If you have connected a suitable decoder, also make sure that the Initial Setup > Audio Out > DTS Out setting is On.

•Some 96 kHz discs do not output audio through the digital jack. In this case, switch the input of your amp/receiver to analog.

•Check the audio cable connections (page 16).

•If the sound is distorted, try cleaning the cable plugs.

Cannot switch a dual	• During real-time copying it is not possible to switch audio channels.
mono program	The main and sub channels are both output.
The picture from the	• If the video signal from the external component is copy-protected,
external input is dis-	you cannot connect via this recorder. Connect the component directly
torted	to your TV.

Screen is stretched ver- • Make sure that the TV Screen Size setting (page 116) is correct for tically or horizontally the kind of TV you have (see also page 120).

•If you have a widescreen TV, check its aspect ratio settings.

•This recorder’s input switches into wide mode automatically according to the input signal. When the unit connected is not compatible with VIDEO ID-1 (widescreen signalling), set the connected component to output 4:3 aspect ratio (standard) video.

122

En