7
Thread lead wires and safety cable through downrod as shown.
10
Install 4 x 25 watt candelabra base bulbs.
13
Install canopy onto downrod.
16
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
8
Install downrod into yoke. Align hole in downrod with hole in yoke and install cross pin. Install keeper into cross pin.
11
Install outer upper glass to fan body.
14
Install half ball on downrod and slide pin into hole in downrod. Then raise half ball so that pin fits in notches in half ball.
17
Raise fan with downrod assembled to the ceiling bracket and hang fan assembly. Be sure to rotate the downrod ball so that the notch in the bracket engages the slot in the ball.
9
Tighten 2 downrod set screws and lock nuts.
12
Install inner upper glass to fan body.
15
Tighen set screw in half ball.
18Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” 
lag lock screw washer
Fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house struc- ture beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.
