Chapter 2: Network Setup
14 Observe the following prompt:
Binary install directory: /opt/MotoMeshDuo _setup/
Configuration install directory: /etc
Ready to install. [Y/n]:
Enter Y to start the installation of the r0k daemon.
15 You may see the following prompt during the r0k daemon installation:
`/opt/MotoMeshDuo _setup/r0kd' -> `/opt/MotoMeshDuo _setup/r0kd'
`/opt/MotoMeshDuo _setup/r0k.conf' -> `/etc/r0k.conf'
r0kd will now be set to startup in runlevels 3-5.
r0kd doesn't appear to be running, start it? [Y/n]:
If you see this, enter N. The daemon will be started later when EAP-TTLS Secure Mesh is
configured.
16 Verify that the hardware IP address assignments are correct. It may take several minutes
for the IP interfaces to come up after the install script completes. At the command prompt
type:
[root@ WMS root]# ip addr
Several lines of text similar to the following will be displayed:
eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000
link/ether 00:0c:76:4e:5b:4e brd ff:ff:ff:ff:ff:ff
inet 172.31.0.20/16 brd 172.31.255.255 scope global eth0
17 Verify that an entry for WMS has been added to the /etc/hosts file. Confirm that the
remaining entries are correct. At the prompt, type the following:
[root@ WMS root]# cat /etc/hosts
Several lines of text similar to the following will be displayed:
127.0.0.1 localhost
172.31.0.20 WMS WMS.meshnetworks.net
18 Try to ping the hostname WMS by typing the following at the terminal window prompt:
[root@WMS root]# ping WMS
Several lines of text similar to the following will be displayed:
PING WMS (172.31.0.20) 56(84) bytes of data.
64 bytes from WMS (172.31.0.20): icmp_seq=0 ttl=0 time=0.047 ms
64 bytes from WMS (172.31.0.20): icmp_seq=2 ttl=0 time=0.040 ms
19 Verify that you get a reply from WMS. Press CTRL-C to return to the terminal window.
Keep the window open for the next step.
2-21