Installation and Removal
Gigabit Ethernet/82543 PMC Installation and Use 1-13
1
5. Remove the screws from the stand-offs on the Gigabit
Ethernet/82543 PMC Module.
6. Identify the PMC slot on the carrier card and insert the PMC's bezel
into the cutout on the front panel of the host module, as shown in
Figure 1-3 on page 1-12.
7. Align the PMC module over the PMC slot connectors: P11, P12 and
P13. Carefully press the PMC module into connectors. Ensure that
standoffs of the module are seated into the mounting holes of the
host board.
8. On the secondary side of the host board, fasten the four screws
through the holes in the host board and the spacers. Tighten the
screws.
The PMC module is now fully installed on the host board. Install the PMC
and host board assembly in its proper card slot by following the procedures
in Installing a Board Module into the Chassis.
For details regarding connecting the Ethernet cable to the RJ–45 connector
on the PMC Module front panel, refer to Connecting the Ethernet Cable to
the PMC Module on page 1-15.
Installing a Board Module into the Chassis
This section describes a recommended procedure for installing a board
module in a chassis.
Before you install your module, please read all cautions, warnings and
instructions presented in this section and the guidelines explained in
Before You Install or Remove a Board on page 1-6.
Use ESD
Wrist Strap
Handling modules and peripherals can result in static damage. Use a
grounded wrist strap, static-dissipating work surface and antistatic
containers when handling and storing components.