
Gigabit Ethernet/82543 PMC Installation and Use IN-5
I
N
D
E
X
Physical requirements ......................B-1
Pin assignments
for cross-over cable connector .3-10
for J1 PCI bus connector ............3-4
for J2 PCI bus connector ............3-5
for J3 PCI bus connector ............3-8
for loopback connector .............3-11
for RJ-45 connector ..................3-10
Ping service .....................................1-16
PMC
description ..................................1-1
PMC (PCI mezzanine card) ..............1-1
disconnecting .............................A-3
faulty .................................A-2, A-3
reseating ....................................A-3
PMC conformance ...........................B-1
PMC slot ..........................................B-1
enabling .....................................A-3
Point-to-point connections ......1-16, A-2
Power ........................................1-1, B-3
maximum ...................................B-3
Power consumption ..........................2-3
Power dissipation ..............................2-4
Power supply rating ..................1-1, B-3
Procedures, network analysis ............1-4
Protocols ..........................................B-1
RRadiated emissions ..........................B-4
Receive frames, buffering .................2-1
Receive signal ........................3-10, 3-11
Regulatory compliance .............2-5, B-4
Relative humidity requirements .......B-4
removal of PMC .............................1-17
REQ signal .................................3-4, 3-7
REQ64 signal .............................3-5, 3-7
Requirements
air flow ......................................B-4
altitude .......................................B-4
environmental ............................B-4
free fall ......................................B-4
physical .....................................B-1
shock .........................................B-4
temperature change ...................B-4
temperature range ......................B-4
vibration ....................................B-4
RJ-45 connector .1-15, 2-1, 3-1, 3-3, 3-9
pin assignments for ..................3-10
pin layout for ..............................3-9
signal definitions for ................3-10
signals for .................................3-10
rlogin service ..................................1-16
RST signal .................................3-5, 3-7
SSBC (single-board computer)
See Host module
SBO signal .................................3-4, 3-7
SDONE signal ...........................3-4, 3-7
SERR signal ...............................3-5, 3-7
Shared Ethernet connnections ...........1-3
Shock requirements .........................B-4
Signal definitions
for PCI bus connectors ........3-6, 3-9
for RJ-45 connector ..................3-10
Signals
for cross-over cable connector .3-10
for J1 PCI bus connector ............3-4
for J2 PCI bus connector ............3-5
for J3 PCI bus connector ............3-8
for loopback connector .............3-11
for RJ-45 connector ..................3-10
interrupt ......................................2-5
Simple Network Management Protocol
(SNMP) ................................1-4
Single-board computer (SBC)
See Host module
Size ..................................................B-1