Installing the Hands Free Kit
Guidelines for Installation and Connection
•Only qualified personnel should install this car kit. If necessary, contact with vehicle manufacturer for air bag information specific to the vehicle.
Caution: An air bag inflates with great force. DO NOT place objects, including communication equipment, in the area over the air bag or in the air bag deployment area. If the communication equipment is improperly installed and the air bag inflates, serious injury could occur.
•Mount components securely on strong surfaces to prevent shifting that could cause injury or interfere with safe vehicle operation. Always use the supplied mounting hardware
•Mounted components and attached wires or cables must not interfere with seating or leg space.
•Route cables so they are protected from pinching, sharp edges, and crushing. Keep all
•This car kit is intended for use in 12 volt negative ground systems only. The car kit draws less than 3 amps. Confirm that the vehicle’s electrical system can supply this current.
Installation Procedure
Caution: This car kit must be connected to a maximum 10A fuse in the car fuse panel to prevent fire or other damages if a short circuit should occur somewhere in the Junction Box.
Before installation, unpack, assemble, and test all components on a service bench.
Installing the Bluetooth Junction Box
Mount the box using the screws provided.
The best location for the Bluetooth junction box is under the dash. The box must be protected from dirt and moisture and have adequate space for cooling and to allow for cable connection.
For optimal Bluetooth performance, mount the junction box so that the side with the barcode faces away from the mounting surface.
Installing the Hands Free Kit
5
