Programming
Your DSR remote control can be programmed to operate your TV and auxiliary components. Follow these instructions to program the remote control.
-Turn on the TV or component you wish to program.
-Use the table in this section to find the brand of the desired component. After the manufacturer’s brand name is one or more
-Press and hold the TV, VCR or AUX key on the remote control until the mode keys on the remote flash.
-While the mode keys are flashing, key in the first of the
-If it is a usable code the mode key will flash rapidly to indicate that it has accepted the code. Press the POWER key on the remote control to make sure the remote control is able to turn your TV or component off and back on.
-If it is not a usable code use the next
Components may respond to more than one code. If your component does not respond to the remote as it should then an alternate code may be more functional or you can try scanning for an alternate code by using the following procedure.
If Your Four-Digit Code is not in the Tables (Scan)
If you try to program your remote control using the
-Turn on the TV.
-Press and hold the TV mode key on the remote control until the mode keys on the remote begin to flash.
-While pointing the remote control at your TV, press the UP navigation key to scan upward to the next code. (Use the DOWN key to return to the previous code.)
-If a transmitted code is the correct one, your
TV will turn off, responding as if its POWER | Up |
key were pressed. The mode key will remain |
|
lighted. Press ENTER and the mode key will |
|
blink rapidly indicating acceptance. |
|
- If your TV does not respond, press the UP |
|
navigation key to try the next code. When |
|
your component turns off you will know that | Down |
you have found the correct code. Press |
|
ENTER to confirm. |
|
-The VCR and AUX keys may be programmed to operate a variety of components but you must first program the selected mode with a valid code or program it using the following starting points: press “1000” if scanning TV codes; “2000” if scanning VCR codes; “3000” if scanning CD or DVD codes; “4000” if scanning audio receiver codes; “5219” if scanning TV/VCR combinations or “6235” if scanning for cable boxes. The mode key will flash rapidly indicating acceptance. Then press and hold the AUX or VCR key untill all the mode keys flash. Press the UP navigation key until your component turns off. Press ENTER and the mode key will flash to indicate acceptance.
19
