2 Connecting Up
Easy setup
This easy setup is the minimum set of connections you need to start watching
Important
•Before making or changing any rear panel connections, make sure that all components are switched off and unplugged from the wall outlet.
•While a connected component is turned on, do not unplug the power cord of this DVD player from the wall outlet. The speaker may be damaged.
2 Connect to a pair of stereo audio inputs on your TV using the supplied Audio/Video cable. You can connect a subwoofer to the SUBWOOFER Jack.
1 | Connect to a composite video | |
input on your TV using the | FLASHER IN | |
| supplied Audio/Video cable. | Control terminal for use by |
|
| custom installers. |
HDMI Ver1.1
CENTER | AUDIO OUT | Y | |
|
| CR | |
L | L | L |
|
R |
|
| R | R |
|
|
FRONT | SUB W. | SURR. | OPT. | MIXED 2CH | COAX. | CB |
|
|
|
|
|
| COMPONENT |
| EXT. INT. |
|
VIDEO A/V EUROCONNECTOR | FLASHER | IN |
| ||
| IN | |
S1 |
| OUT |
|
| |
|
| REMOTE CONTROL |
AC IN
See Note: | 3 | Plug into a standard | ||||
EXT. INT. | AC wall outlet. | |||||
Remote Switch |
|
|
|
| ||
|
|
|
|
|
| |
|
|
|
|
|
|
|
Connecting audio/video cables |
| Note | ||||
Be sure to insert each |
| • When connecting to a standard TV, select | ||||
plug fully for the best |
| |||||
| 4:3 LETTER BOX or 4:3 PAN SCAN in the TV | |||||
connection. The plugs |
| Aspect setting (see page 43). | ||||
and jacks are |
| • Connect the video output of the player directly | ||||
to make connection |
| to your TV. Because the player is designed to | ||||
easier. |
| support an Analog Protection System copy card, | ||||
| there are cases when proper playback will be | |||||
|
|
|
|
|
| |
|
|
|
|
|
| not be possible if the player is connected to the |
Connecting system control cables |
| TV through a VCR and images are recorded and | ||||
By connecting this DVD player to another |
| played on the VCR. | ||||
|
| |||||
Marantz audio component using a supplied |
| • The player’s video output and S1 output are not | ||||
| be progressive. | |||||
system control cable, you can remotely |
| |||||
| • Remote switch | |||||
operate the components as a single system. |
| |||||
•When connecting to a component with a remote sensor, be sure to connect the REMOTE CONTROL IN jack of this DVD player to
the REMOTE CONTROL OUT jack of the component with the remote sensor.
•When connecting to component which is not equipped with a remote sensor, be sure to connect the component to the REMOTE CONTROL OUT jack of this DVD player.
When using this DVD player independently, set this switch to INT. (INTERNAL). When using this DVD player in a system with a Marantz receiver equipped with a remote sensor, set the switch to EXT. (EXTERNAL).
•Flasher Input
This is used when controlling components from different rooms with a keypad or other input device. Set the remote switch to EXT. (EXTERNAL) when using a flasher input.
10
