Additional Information
The remote control doesn't seem to work.
•The remote control is too far from the player, or the angle with the remote sensor is too wide.
Use the remote control within its operating range (page 7).
•The batteries are exhausted.
Put in new batteries (page 7).
Cannot listen to
•LPCM Out is set to 48 kHz. Set it to 96 kHz.
•As a
In this case, even if 96 kHz is selected, the player automatically outputs the audio at 48 kHz. This is not a malfunction.
No audio, or audio is distorted.
•Some DVD discs do not output digital audio.
Switch your amplifier to the player's analog outputs.
•Dirt, dust, etc. on the disc. Clean the disc (page 52).
•Interconnectors are not fully inserted into the terminals (or are not connected).
Check that all interconnectors are firmly inserted.
•Dirty or oxidized plugs/terminals.
Clean the plugs/terminals.
•Incorrect audio cable connection.
Check the audio connections (pages 10 to 12).
•Player's output is connected to the amplifier's phono (turntable) inputs.
Connect to any set of inputs except phono.
•The disc is paused.
Press 3 (PLAY) to exit the pause mode.
•Incorrect amplifier settings.
Check that the volume is turned up, that the speakers are on, the input function set correctly, etc.
The analog audio is OK, but there appears to be no digital audio signal.
•Incorrect AUDIO SETUP menu settings.
Make sure that the DIGITAL OUT setting is set to ALL or PCM (page 39).
Check the amp's instruction manual.
Noticeable difference in DVD and CD volume.
•DVDs and CDs use different recording methods. This is not a malfunction.
Cannot output 192 kHz or 176.4 kHz digital audio.
The player does not output digital audio at these sampling rates.
Cannot output 96 kHz or 88.2 kHz digital audio.
•Check that the LPCM OUT setting is not set to 96 kHz (page 39).
•Some discs are digital
No DTS audio output.
•If this unit is connected to a
•If this unit is connected to a
7
English
55
