mode” tone until the mode selector knob and
NOTE: If the channel is busy during conven- tional operation, the radio’s red LED will blink in receive operation.
NOTE: The red LED will blink if a
Call Light (Trunking Only)
If this feature is enabled on a group or a universal ID that is re- ceived, then the green LED will blink. To turn off the call light, change the group or mode, press the PTT, or press any valid but- ton.
Monitoring a Conventional Channel
1.To unsquelch the radio while on a conventional channel, press side button 3. This unmutes the speaker (if open squelch monitor is programmed using RSS). You may then adjust the volume with the on/off/volume control.
2.To place the radio in the permanent monitor mode, press and hold side button 3 for approximately 2.5 seconds (time programmable using RSS). The radio emits a brief
Transmitting on a Trunked System
1.Press the PTT switch.
2.If the