iDEN® iO1500R

OEM Modem Developer’s Kit

User Guide

Important note for U.S. Domestic Integrators

All OEM integrators whose device(s) operates on public carrier networks, licensed in the U.S., must adhere to FCC E911 Phase II regulations. Severe penalties can be levied for failing to adhere to E911 guidelines.

General

About iDEN Developer’s Kit

The iDEN Developer’s Kit for iO1500R OEM modem provides the capability of transferring data and voice from an external equipment to the iDEN network using the iO1500R (iO1000) module.

The kit includes an Evaluation Board that is designed to accommodate the OEM module and other supporting components. A flex cable connected to the 30-pin ZIF connector is used to connect the iO1500R module to the evaluation board. The OEM modem RF connector provides the path to receive and transmit data from the iDEN network.

The "iO1500R developers kit", FTN6363A includes the following accessories: Evaluation board w/voice - FCN6412A

Data cable (RS-232) - FKN4369A 30 pin flat cable - 3086229J03

MMCX to Mini UHF jumper cable - 3002823C34 Antenna - RAF4136AMM

Mounting kit – FHN6525A

Board Set-Up

Unpack the mounting accessories.

Attach the 5 mounting rubber supports to the 4 corners and center points of the back side of the board and put it on your desk (see board layout below).

Used the 4 screws and washers to screw an iO1500R (18) OEM modem to the board. Verify that a SIM card (17) is inserted.

Connect the 30 pin flat cable (16) from the modem to the board. Connect the RS-232 cable from the board (10) to your PC.

Connect the antenna jumper cable (19) from the modem to the external antenna. Connect the audio accessories (if your application requires voice operation). Set all switches to the proper position (see detail interface description below). Connect DC power (3) and switch on the power to the board (1).

Page 2 of 8

Page 2
Image 2
Motorola manual IDEN iO1500R, General, Board Set-Up