3.20.3Three-party conference call
1.During an external home call, press MENU. - Your caller is put on hold.
2.Press VOL+ or REDIAL/VOL- to select the handset you want to call.
3.Press MENU to call the handset.
4.When the other handset answers the intercom call, press MENU on the calling handset to set up the conference call.
5.Press 
/BACK on any handset to hang up three- party conference and leave the other handset in external line with the caller.
3.21Set the dial mode
The default dialing mode is suitable for your country and network operator. It is unlikely that you should need to change this setting unless advised to do so.
1.Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS.
2.Press MENU to select DIAL MODE.
3.Press MENU and VOL+ or REDIAL/VOL- to select TONE
or PULSE.
4.Press MENU to save.
NOTE
If pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily when dialing out. After the call is ended, the dial mode will change back to pulse.
3.22Set the Flash Time
The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so.
1.Press MENU and then VOL+ or REDIAL/VOL- to select
SETUP BS.
2.Press MENU and then VOL+ or REDIAL/VOL- to select
FLASH TIME.
3.Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want. (8 options are available: 90, 100, 110,
250, 300, 400, 600 and 700MS)
4.Press MENU to save.
24 | Using the phone |
|
|
