Motorola L512BT, L515BT, L514BT, L502BT, L513BT, L511BT manual Phonebook entry cannot be stored

Models: L502BT L512BT L513BT L514BT L515BT L511BT

1 43
Download 43 pages 2.43 Kb
Page 32
Image 32

Caller ID does not work

Check your subscription with your network operator.

If you subscribe to high-speed internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

A phonebook entry cannot be stored

• The phonebook is full. Delete an entry to free memory.

No display

Try recharging or replacing the rechargeable battery pack.

Reset the base. Unplug the unit's electrical, then plug it back in.

If the LED is not lit up, then try to unplug the unit's electrical power, and then plug it back in.

If the handset disconnects from the base during a phone call

Check that the power cord is connected properly into the base.

Check that the power adapter is connected properly into the electrical outlet.

Move the handset closer to the base. It may be out of range.

Reset the base by unplugging the unit's electrical power. Wait for around 15 seconds and re-plug the power again. Allow up to one minute for the handset to synchronize with the registered base again.

Noise interference on your radio or television

Your base or charger may be too close. Move it as far away as possible.

32

Help

 

 

Page 32
Image 32
Motorola L512BT, L515BT, L514BT, L502BT, L513BT, L511BT manual Phonebook entry cannot be stored