Motorola L515BT, L514BT, L512BT, L502BT, L513BT, L511BT manual Getting started, Location, Setting up

Models: L502BT L512BT L513BT L514BT L515BT L511BT

1 43
Download 43 pages 2.43 Kb
Page 6
Image 6

1. Getting started

WARNING

Do not place your phone in the bathroom or other humid areas.

Location

When choosing a location for your new phone, here are some important guidelines you should consider:

Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, heating appliances and direct sunlight.

Avoid areas of excessive dust, moisture, and low temperature.

Avoid other cordless telephones or personal computers.

Never install telephone wiring during a lightning storm.

Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

Never touch non-insulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

Use caution when installing or modifying telephone lines.

6

HANDSET RANGE

Optimal range is reached when there are no other electrical appliances working within the range area. Any obstruction between the base and handset will also reduce the range significantly.

SIGNAL STRENGTH

When out of range of the base, the screen shows SEARCHING.... If you are on a call, the line will disconnect.

Move back within in range of the base. The handset will automatically re-connect to the base.

Setting up

IMPORTANT

The base must be plugged into an electrical outlet at all times. Do not connect the telephone line cord into a power outlet until the handset is fully charged. Only use adapter and telephone line cord supplied with the product.

WHICH POWER ADAPTER

The power adapter with the smaller pin is for the base unit and the power adapter with the larger pin is for the charger unit (only for multi-handset packs).

Getting started

Page 6
Image 6
Motorola L515BT, L514BT, L512BT, L502BT, L513BT, L511BT manual Getting started, Location, Setting up