Motorola RMV2080, RMU2080 manual Example of Programming a Code, Example of Programming Auto-Scan

PROGRAMMING FEATURES

Example of Programming a Code

Assuming the current code value is set to factory default ‘001’, and you want to change it to CTCSS/DPL Code = 103. Follow the sequence indicated below:

1.Enter Advanced Configuration Mode.

2.Short press the PTT button twice. The radio audible voice announced “Code Number” (Entering CTCSS/DPL Programming Selection Mode).

3.Pressing and holding SB1 or SB2 button fast forwards / rewinds the value at the nearest 10’s. When released, the radio audible voice announces the first, second and third digit in full. Keep pressing the SB1 or SB2 button several times until you hear “103”.

4.Long press the PTT button. LED Indicator shows a green heartbeat to indicate ‘Idle’ Programming Mode.

5.Long press the PTT button again to exit Programming Mode or turn OFF the radio.

Example of Programming Auto-Scan

Auto-Scan is the third available feature in the Programming Mode and can be set to either ON or OFF on a particular channel.

To set Auto-Scan to ON:

•Enter Advanced Configuration Mode and select the desired channel.

•Short press the PTT button three times to enter the Active Channels Programming Selection Mode. The audible voice in the radio announces “Auto-Scan” and the setting (Enabled or Disabled).

•To change the setting, press SB1 or SB2.

•Long press the PTT button. LED Indicator shows a green heartbeat to indicate ‘Idle’ Programming Mode.

•Long press the PTT button again to exit Programming Mode or turn OFF the radio.

English 38