Target Radio Display
k 188
218
Source Radio Display

Cloning

The X Series radios have cloning capability when connected via the 53879 Multi-Unit Charger (MUC). Cloning enables rapid fleet reconfiguration because all selectable settings are sent to the target unit. The Target radio must be placed behind the Source radio and turned On. Radios must be of the same band; UHF or VHF. Multi-channel models can Clone to single-channel radios, but only the first channel is cloned. Please refer to the MUC User's Guide included with this accessory.

• Make sure k is accessed. Please refer to page 11.

• The source radio enters Cloning Mode and clones through an extended press of J.

Either W for pass or N for fail appears on the Source

Radio Display.

If cloning was successful all segments on the Target

Radio Display will light up. Turn radio Off and back On again to use.

• Pressing J again will clone additional radios.

Note: The MUC does not need to be plugged in for Cloning feature to work.

Resetting Factory Defaults

All selectable features can be reset to factory defaults by turning the radio On while holding M and \ buttons simultaneously for three seconds.

Note: The radio cannot be reset if Manager Lock is enabled.

k

Programming Mode

23

Page 35
Image 35
Motorola XV2600, XU1100 manual Cloning, Resetting Factory Defaults