Moxa Technologies EDS-508 manual Wiring the Redundant Power Inputs

Installing MOXA EtherDevice Switch

Wiring the Redundant Power Inputs

EDS-508 has two sets of power input— power input 1 and power input 2.The top two contacts and the bottom two contacts of the 6-pin terminal block connector on EDS’s top panel are used for dual DC power input. Top and front views of terminal block connectors are shown here.

STEP 1: Insert the negative/positive DC wires into the V-/ V+ terminals.

STEP 2: To keep the DC wires from pulling loose, use a small flat-blade screwdriver to tighten the wire -clamp screws on the front of the terminal block connector.

STEP 3: Insert the plastic terminal block connector prongs into the terminal block receptor, which is located on EDS-508’s top panel.

MOXA EtherDevice Switch Hardware Installation Guide 3-5