Printer Requirements:
The recommended memory configuration is as follows:
Requirement | Minimum | Recommended | Recommended |
| installed | minimum memory | minimum memory |
| memory | (simple text) | (pages with overlays |
|
|
| or graphics) |
|
|
|
|
A4/Letter simplex | 8 MB | 8 MB | 12 MB |
|
|
|
|
Printer
HP2100
Minimum Printer firmware date code
19990105
IPDS DIMM firmware(or later versions)
S93 162.084
HP JetDirect EIO (600 N J3111A/Ethernet)
HP JetDirect EIO (600 N J3112A/Tokenring)
HP JetDirect EIO (600 N J3113A/10/100Tx Eth)
HP settings:
1.Set the IP, Subnet Mask, and Gateway address on the JetDirect card.
2.The printer's PS wait
3.The JetDirect card's IDLE TIMEOUT shall be set to 3600 sec or 0 (zero).
4.Remember to power cycle printer to enable new settings.
4.1AS/400 Settings for Version 3.1
To configure IPDS printing on AS/400 V3R1, you must use two commands:
-CRTDEVPRT
-WRKAFP2
4.1.1 Configuring PSF with CRTDEVPRT on V3R1
On V3R1, at the AS/400 command line, enter a command in the form:
CRTDEVPRT DEVD(HP_IPDS) DEVCLS(*RMT) TYPE(*IPDS) MODEL(0) AFP(*YES) AFPATTACH(*APPC) FONT(11)RMTLOCNAME(TCPIP) FORMFEED(*AUTOCUT) TEXT('IDATA IPDS DIMM')
11
