MHT HEATER ASSEMBLY INSTRUCTIONS
1.Place gaskets from Gasket kit (02885) on each side of the burner box. Use the four mounting studs around each of the
2.Slide the tube flanges over the studs as was done in the prior step with the gaskets. The tube ends extend through the flanges to help with alignment.
3.Using the four long and four short nuts from the bolt kit (02876) secure the tube set to the burner box. As shown in the diagram, use the four long nuts in the center and the four short nuts on the outside.
4.Slide the bulkhead and reflector assembly forward until it stops on the long nuts. Using the (4)
USE CAUTION AS NOT TO OVERTIGHTEN ASSEMBLY AS IT MAY CAUSE DAMAGE TO PARTS OF ASSEMBLY
Mr. Heater | 11 | Operating Instructions and Owner’s Manual |