MTD A06, Wood Splitter manual The maximum tyre pressure is, Attaching the mudguards optional Fig

English Operating Manual for Wood Splitter

•Tighten the castellated nut until it is tight, then slacken it by approx. 1/3 revolution and until one of the slots in the nut is facing the hole in the axle.

•On both wheels insert a cotter pin through the slot in the nut and through the hole in the axle and secure by bending out the ends. Note: The wheels should rotate freely and there should be no lateral play.

Place the caps on the hubs and tap into place with a rubber mallet.

Attention!

The maximum tyre pressure is

2 bar. The tyre pressure should always be the same for both tyres.

Attaching the mudguards (optional) Fig. 1

•Remove nuts, lock washers, washers and hexagon bolts from the mudguards.

•Attach mudguards to the hydraulic tank with bolts, washers, lock washers and nuts from step 1.

Attaching the connecting rod Figs. 2a and 2b

•Remove the bolts (2) and nuts (4) from the front of the hydraulic tank.

•Position the connecting rod (3) and attach with the bolts and nuts from step 1.

•Lower the hydraulic tank (1) and place on the attached wheels.

•Fold out the support:

–Remove the spring cotter (7) and pin (8).

–Fold out the support (5) and fix to the connecting rod with the pin and spring cotter.

1

2

3

4

Fig. 2a

6	8
	7
5

Fig. 2b

Attaching the splitting column

Fig. 3

Place the unit consisting of the splitting wedge, splitting column and cylinder in an upright position. Note: Two persons may be required for this.

•Remove the pin (1) and cotter pin

(2) from the holders and position the hydraulic tank (4) relative to the column.

•Insert the pin, which has just been removed, through the holders on the splitting column and the holder on the hydraulic tank unit. Secure with cotter pin (bend out the ends).

	2
1	3
	4
	Fig.3

Attaching the high-pressure hoses Fig. 4

•Remove the protective cap from the connecting piece on the side of the pump (a little oil may flow out of the pump).

3

5

4

2 6

1

7

Fig.4

1Position of the high-pressure hose between connecting rod and column

2Connecting rod

3Splitting column

4Hose connecting piece

5Pump

6Intake hose

7High-pressure hose

•The high-pressure hose is connected to the control valve. Feed the hose between the column and the connecting rod and connect to the connecting piece on the pump.

Attaching the return-flow hose Fig. 5

•Loosen the hose clip (2) on the free end of the return-flow hose and remove the protective insert from the end of the hose.

•Remove the protective cap from the connecting piece at the top of the filter head. Attach the end of the hose to the connecting piece (at the top of the filter head) and secure with the hose clip (tighten well).

3