| English |
| Operating Manual for Wood Splitter | |||
| Troubleshooting the engine |
|
|
|
| |
| Problem |
| Cause |
| Solution | |
Engine does not start |
| Ignition cable removed. | Reconnect ignition cable to spark plug. | |||
|
|
| Tank empty or fuel stale. | Top up tank with fresh, clean petrol. | ||
|
|
| Throttle/engine operating switch not in start | Set throttle to | or engine operating switch to “ON”. | |
|
|
| position. |
|
|
|
|
|
| Choke not actuated | Actuate choke. |
|
|
|
|
| Spark plug defective. | Clean, adjust or change. |
| |
Engine is misfiring |
| Connect |
| |||
|
|
| Choke still actuated. | Set choke lever to OFF. |
| |
|
|
| Fuel line blocked or petrol stale. | Have fuel line cleaned. Top up tank with fresh, clean | ||
|
|
|
| petrol. |
|
|
|
|
| Air filter dirty. | Clean or change air filter. |
| |
|
|
| Carburettor misaligned. | Contact an authorised dealer. |
| |
Engine is overheating |
| Too little engine oil. | Top up crankcase with correct oil. | |||
|
|
| Air filter dirty. | Clean or change air filter. |
| |
|
|
| Carburettor incorrectly set. | Contact an authorised dealer. |
| |
| Troubleshooting the hydraulics |
|
|
| ||
| Problem |
| Cause |
| Solution | |
Hydraulic splitting cylinder |
| Drive shaft broken. | Contact an authorised dealer. |
| ||
does not move |
| Shaft coupling slack. | Contact an authorised dealer. |
| ||
|
|
| Gearwheel areas damaged. | Contact an authorised dealer. |
| |
|
|
| Contact an authorised dealer. |
| ||
|
|
| Hydraulic lines blocked. | Contact an authorised dealer. |
| |
|
|
| Oil level too high/low. | Check oil level. |
|
|
|
|
| Control valve damaged/blocked. | Contact an authorised dealer. |
| |
Hydraulic splitting cylinder |
| Gearwheel areas damaged. | Contact an authorised dealer. |
| ||
moves slowly to and from |
| Engine speed too low. | Set throttle on the engine to | . | ||
|
|
| Contact an authorised dealer. |
| ||
|
|
| Oil level too high/low. | Check oil level. |
|
|
|
|
| Oil contaminated. | Contact an authorised dealer. |
| |
|
|
| Control valve leaking internally. | Contact an authorised dealer. |
| |
|
|
| Cylinder damaged internally. | Contact an authorised dealer. |
| |
Hydraulic cylinder leaking |
| Seals broken. | Contact an authorised dealer. |
| ||
|
|
| Cylinder run in. | Contact an authorised dealer. |
| |
Engine is running, but wood is |
| Small gearwheel area damaged. | Contact an authorised dealer. |
| ||
not being split or is being split |
| Contact an authorised dealer. |
| |||
too slowly |
| Oil level too high/low. | Check oil level. |
|
| |
|
|
| Oil contaminated. | Contact an authorised dealer. |
| |
|
|
| Control valve leaking internally. | Contact an authorised dealer. |
| |
|
|
| Cylinder overloaded. | Do not attempt to split wood against the grain. | ||
|
|
| Cylinder damaged internally. | Contact an authorised dealer. |
| |
Engine stalls during the |
| Too little power / weak engine. | Contact an authorised dealer. |
| ||
splitting process |
| Cylinder overloaded. | Do not attempt to split wood against the grain. | |||
Engine is not running or stalls |
| Hydraulic pump defective. | Contact an authorised dealer. |
| ||
under load |
| Engine has too little power. | Contact an authorised dealer. |
| ||
|
|
| Hydraulic lines/control valve blocked. | Contact an authorised dealer. |
| |
Pump shaft seal leaking |
| Drive shaft broken. | Contact an authorised dealer. |
| ||
|
|
| Gearwheel areas damaged. | Contact an authorised dealer. |
| |
|
|
| Shaft seal defective. | Contact an authorised dealer. |
| |
|
|
| Vent hole in the oil tank blocked. | Ensure that the tank has been vented correctly. |
Note: Contact an authorised customer service for repairs which go beyond the measures mentioned above.
11