Chapter 2 - Installation

6.Use the list box to select the Switch Type. If you are not sure which Switch Type to select, contact your ISDN provider. If your telephone service provider uses MSN (Multiple Subscriber Numbers) or SAD (Sub-Addressing), enter the information given to you by your ISDN provider in the appropriate fields. If your ISDN service requiresSPIDs (Service Provider IDs), enter these values in the SPID1 and SPID2 fields. Refer to Chapter 2 “Before You Begin” for more information.

Note: If you plan to use PTP Mode (Point to Point Mode) or X.25 select those options here.

7. Click on the NDISWAN Setting tab and enter any necessary phone number information.

Note: After installation and any time you make changes to values within the ISDN configuration dialog box, you will need to restart Windows NT for the settings to take effect.

8.When complete, Click OK to continue. The RAS Setup Message appears as shown in figure 2-6. Click OK to continue the installation.

Figure 2-6. Remote Access Service Setup Message

9.Click OK to install and setup RAS.

10.The screen shown in figure 2-7 appears.

Figure 2-7. Adding a RAS device

11.If you do not see ISDN1-IINWANNTlisted in the port fields, click Add.

12.From the list box, select ISDN1-IINWANNTand click OK. The first NDISWAN device is added to the Remote Access Setup Port list.

MT128ISA/PCI

18