
Chapter 4 - Manual Dial and Automatic Answer
4.3Automatic Leased Line Restoral Operation
When the modem is in Dial Backup mode, it periodically checks the leased line to see if it's operational and tries to restore the leased line if possible.
Note: both local and remote modems must have
4.4Manual Dial Backup Call Termination
With your modem in leased line mode
1)Manual Control. The "Voice/Data" switch can be used to change from a dial back line to leased line by toggling down once. When that is done, the modem tries the leased line connection, and, if it is good, the modem disconnects the dial back call and establishes a leased line connection.
2)DTR Control. If DTR (Data Terminal Ready) is turned off for 50 milliseconds or more, a disconnect occurs. This is probably the most common method used by computer systems at the automatic answer end of the line to cause the answering modem to disconnect after toggling off procedures.
4.5Dial Backup and Leased Line Restoral
The dialing associated with the MultiModem, when in leased line with
After a preset period of time (determined by
The parameters used to determine if a leased line is down (so automatic dial back can occur), is based on the modem doing a “retrain” on the leased line due to an error condition in the transmission. An error condition is defined as a "hit" on the line (the Carrier gets interrupted).
The retrain is a "handshake" procedure between the modems to establish the Carrier again. If the retrain fails, both modems (originate and answer modems) start their
The purpose of the timer for the Answer modem is to determine when it accepts a
23 |