
Chapter 7 - Callback Security and Remote Configuration
The + and/or - characters entered before the phone number are optional. The + (Deposit Number) code allows a caller to enter the number he or she wishes the Callback modem to call back when the caller uses a particular password (Step 3 of Table
The ??? entry at the end of the phone number is optional and indicates a subcode number to the main phone number for that location. The ??? used to dial different extensions at the same basic number. To use this optional feature, enter the number of ? marks where indicated equal to the number of digits in the desired extension number, (i.e., with a 4 digit extension enter ????). When a caller uses that particular password (Step 3 of Table
Note: To view Callback Passwords/Numbers, use the L Command.
6.To store changed parameters to memory, enter AT&W0 and hit RETURN.
Note: If you have enabled Callback Security (#DB1 in step 2 of Table
7.Enter your modem's LOGIN Password (as selected in Table
8.Enter your modem's Setup Password (as selected in Table
Table 7-3. Callback Operational Sequence Procedures
Perform the following steps when dialing into a dialback modem:
1.When called, the modem answers and after a slight delay, responds with: Password>
2.Enter your modem's LOGIN Password (Table
DB>
3.Enter the Callback Password corresponding to the phone number you wish called back and hit RETURN (Callback Passwords and phone numbers entered in Table
You have three tries at each prompt to enter the information properly, with an incorrect entry resulting in a password retry. You must enter the requested information correctly within one minute or the Callback modem will
Password>
4.Enter the modem's LOGIN Password again (the same as in Step 1). The Callback modem responds with:
CONNECT
You are now in Data Mode.
72 |