Multi-Tech Systems MTASR3-200 - page 65

Appendices
MTASR3-200 65
Command: &J n Auxiliary Relay Control
Values: n = 0
Default: 0
Description: &J0 The auxiliary relay is never closed.
&J1 Not supported—responds ERROR.
Command: &K n Local Flow Control Selection
Values:
n = 0, 3, or 4
Defaults: 3
Description: &K0 Flow control disabled.
&K3 Enable CTS/RTS hardware flow control.
&K4 Enable XON/XOFF software flow control.
Command: &M
n Communications Mode
Values:
n = 0
Defaults: 0
Description: &M0 Asynchronous mode.
&M1 Reserved—responds ERROR.
Command: &Q n Asynchronous Communications Mode
Values: n = 0, 5, or 6
Defaults: 5
Description: &Q0 Asynchronous with data buffering. Same as \N0 .
&Q5 Error control with data buffering. Same as
\N3 .
&Q6 Asynchronous with data buffering. Same as
\N0 .
Command: &S
n Data Set Ready (DSR) Control
Values:
n = 0 or 1
Default: 0
Description: &S0 Force DSR high (on).
&S1 Let DSR follow CD.
Command: &T
n Self-Test Commands
Values:
n = 0, 1, 3 or 6
Default: None
Description: &T0 Abort. Stop any test in progress.
&T1 Local analog loop test.
&T3 Local digital loopback test.
&T6 Remote digital loopback test.
Command: &V View Current Configuration
Values: n/a
Description: Displays the active modem settings.
Command: &W
n Store Current Configuration
Values:
n = 0
Default: None
Description: &W0 Store active modem settings in NVRAM; load them at power-on or following the ATZ command
instead of loading the factory defaults from ROM.
Command: &Y
n Select Stored Configuration for Hard Reset
Values:
n = 0
Default: 0
Description: &Y0 Select stored configuration 0 on power-up. (For backward compatibility with some software.)
&Y1 Not supported—responds ERROR.
Command: &Z n = x Store Telephone Number
Values:
n = 0, 1, 2, or 3
x = Dialing string
Default: None
Description: Stores telephone dial string
x in memory location n . Dial the stored number using the command
ATDS=n .