Multiquip 21362 manual HPLA/HPHA-SERIES 36TROWEL- PRE-INSPECTION, Instructions, Before Starting

HPLA/HPHA-SERIES 36"TROWEL— PRE-INSPECTION

CAUTION

NEVER operate the trowel in a confined area or enclosed area structure that does not provide ample free flow of air.

ALWAYS wear approved eye and hearing protection before operating the trowel.

NEVER place hands or feet inside the guard rings while the engine is running.ALWAYS shut the engine down before performing any kind of maintenance service on the trowel.

Figure 16. Engine Oil Dipstick (Removal)

3.Insertandremovethedipstickwithoutscrewingitintothefiller neck. Check the oil level shown on the dipstick.

4.If the oil level is low (Figure 17), fill to the edge of the oil filler hole with the recommended oil type (Table 3).Maximum oil capacity is 1.16 US Qt. (1.1 liters).

It is recommended that the trowel's safety stop switch be used
to stop the engine after every use. Doing this will verify that the			Reference manufacturer engine
switch is working properly and presents no danger to the operator.
		NOTE	manual for specific servicing
			instructions.
Before Starting
1.	Read safety instructions at the beginning of manual.
2.	Clean the trowel, removing dirt and dust, particularly the
	engine cooling air inlet, carburetor and air cleaner.
3.	Check theairfilterfor dirtanddust. Ifairfilterisdirty,replace
	air filter with a new one as required.
4.	Check carburetor for external dirt and dust. Clean with dry
	compressed air.

5. Check fastening nuts and bolts for tightness.

Engine Oil Check

1.Tochecktheengineoillevel,placethe trowelonsecurelevel ground with the engine stopped.

2.Remove the filler dipstick from the engine oil filler hole (Figure 16) and wipe it clean.

Figure 17. Engine Oil Dipstick (Oil Level)

Table 3. Oil Type

Season	Temperature	Oil Type
Summer	25°C or Higher	SAE 10W-30
Spring/Fall	25°C~10°C	SAE 10W-30/20
Winter	0°C or Lower	SAE 10W-10

PAGE 22 — HPLA/HPHA-SERIES 36" WALK-BEHINDTROWEL— OPERATION AND PARTS MANUAL — REV.#3 (07/06/10)