Multiquip operation manual DCA-36SPX Gauge READING/TERMINAL Panel Connections

DCA-36SPX — GAUGE READING/TERMINAL PANEL CONNECTIONS

How to Read the Output Terminal Gauges.

The gauges on the control panel are provided to help observe how much power is being supplied at the Output terminals lugs.

Reading Amperage

To determine the amperage at a terminal lug, set the AC Ammeter Change-Over Switch to the appropriate setting (Figure 15) to activate the AC Ammeter Gauge (Figure 16) and read the available amperage at the terminal lug.

For example, to measure the amperage at the U terminal lug, set the AC Ammeter Change-Over Switch to U and read the AC Ammeter Gauge.

Figure 17. Output Terminal Lugs

240 Single Phase Connections

2.Turn the voltage regulator knob (Figure 18) clockwise to increase voltage output, turn counterclockwise to decrease voltage output.

Figure 15. AC Ammeter	Figure 16. AC Ammeter	Figure 18. Voltage Regulator Knob (139V/240V)
Change-Over Switch	(Amp reading on U lug)	1Ø 120 Output Terminal Lug Voltages

The ammeter gauge will only

NOTEshow a reading when the Output Terminal Lugs are connected to a load and in use.

UOV Terminal Output Voltages

240/120V output voltages can be obtained using the Output Terminal Lugs..

The voltage regulator (VR) allows the user to increase or decrease the selected voltage.

1Ø 240 Output Terminal Lug Voltages

1.Connect the load wires to the OutputTerminal Lugs as shown in (Figure 17)

1.Connect the load wires to the OutputTerminal Lugs as shown in (Figure 19)

Figure 19. Output Terminal Lugs

120 Single Phase Connections

2.Turn the voltage regulator knob (Figure 18) clockwise to increase voltage output, turn counterclockwise to decrease voltage output.

PAGE 30 — DCA-36SPX— OPERATION AND PARTS MANUAL — REV. #1 (04/14/10)