Multiquip operation manual DCA-400SSK Generator START-UP Procedure KEY Switch

DCA-400SSK — GENERATOR START-UP PROCEDURE (KEY SWITCH)

2. Connect the load to the UVW terminals as shown in 4. Close all engine enclosure doors (Figure 34). Figure 32. These terminals can be found on the output

terminal panel, see page 35 Figure 14. To gain access to the output terminals lift the UVW cover. Make sure to tighten terminal nuts securely to prevent load wires from slipping out.

Figure 34. Engine Enclosure Doors

5. Set the battery ON/OFF switch (Figure 35) to the ON position.

Figure 32. UVW Terminal Lugs (Load)

3.Connect the negative battery cable (BLACK) to the negative post on the battery (Figure 33).

Figure 35. Battery ON/OFF Switch

NEGATIVE

POSTIVE

BATTERY

Figure 33. Battery Connections

6.When starting the generator in COLD weather conditions, press and hold the engine preheat button (Figure 36) until the preheat lamp (Figure 37) is lit (ON).

Figure 36. Engine Pre-Heat Button

Figure 37. Engine Pre-Heat Lamp

PAGE 48 — DCA-400SSK — PARTS AND OPERATION MANUAL (STD)— REV. #3 (09/17/01)