inspection/SETUP
Circuit Breakers
To protect the generator from an overload, a
Lubrication Oil
Fill the engine crankcase with lubricating oil through the filler hole, but DO NOT overfill. Make sure the generator is level and verify that the oil level is maintained between the two notches (Figure 28) on the dipstick. See Table 11 for proper selection of engine oil.
Figure 28. Engine Oil Dipstick
When checking the engine oil, be sure to check if the oil is clean. If the oil is not clean, drain the oil by removing the oil drain plug, and refill with the specified amount of oil as outlined in the ISUZU Engine Owner’s Manual. Oil should be warm before draining.
Other types of motor oils may be substituted if they meet the following requirements:
API Service Classification CC/SC
API Service Classification CC/SD
API Service Classification CC/SE
API Service Classification CC/SF
Table 11. Recommended Motor Oil |
Fuel Check
DANGER
Fuel spillage on a hot engine can cause a fire or explosion. If fuel spillage occurs, wipe up the spilled fuel completely to prevent fire hazards. NEVER smoke around or near the generator.
Refilling the Fuel System
CAUTION
ONLY properly trained personnel who have read and understood this section should refill the fuel tank system.
This generator has a fuel tank located inside the trailer frame. (Figure 29). ALWAYS fill the fuel tank with clean fresh #2 diesel fuel. DO NOT fill the fuel tank beyond its capacity.
Pay attention to the fuel tank capacity when replenishing fuel. The fuel tank cap must be closed tightly after filling. Handle fuel in a safe container. If the container does not have a spout, use a funnel. Wipe up any spilled fuel immediately.
FUEL TANK
FILLER NECK
Figure 29. Trailer Fuel Tank
page 28 — DCA25SSIU3 (with MLT25 series) • operation and parts manual — rev. #1 (01/24/13)
