PAGE 18 — EM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (008/10/04)
EM-70 PLASTER/MORTAR MIXER — ELECTRIC MOTOR
Electric Motor
For maintenance care and operation of the electric motor,
refer to your electric motor instruction booklet furnished with
the motor.
Protect the electric motor from dust as much as possible
and keep ventilating openings clean.
It is strongly recommended that all
electrical wiring be done by a

licensed electrician

.
Special attention should be given to the electric switch as
well as the over-and-under voltage protection devices as
per regulations set forth in the local electrical safety code
handbook
DO NOT spray water at any time on the

electric motor

.
DO NOT operate electric motor in a explosive environment.
The electric motor used in this mixer is a single-phase 1.5
HP motor. The input voltage requirement for this motor is
either 115 or 230 VAC only.
Electric Motor Connection
A 12-inch electrical cable (Figure 7) is provided with the
electrical motor for hookup to a power source. Table 5 shows
the required NEMA connector for the desired motor
horsepower rating. In addition, Table 5 also shows the
matching NEMA approved connector for the required
extension cord.
Figure 7. Single Phase Electric Motor With
12-inch Pigtail
NOITAMROFNIGNIRIWROTOMCIRTCELE.5ELBAT
rotoM
rewopesroH
gnitaR
esahPelgniS-CAV032-511
rotcennoCgulPAMEN AMEN
gnitaM
rotcennoCelcatpeceR
PH5.1
)CAV511( 735049MEN/PP02-5L835049MEN/PR02-5L
PH5.1
)CAV032( 935049N/PP02-6L045
049N/PR02-6L
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
NOTE
ALWAYS
make certain that the power source required
for the electric motor is

correct

and always use the correct
NEMA configuration plug.

Failure

to supply the correct
voltage to the motor can severely damage the motor.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Electric Motor
Connections
Electric Motor
Safety