EM-70 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (008/10/04) — PAGE 27
EM-70 PLASTER/MORTAR MIXER — SHUT-DOWN PROCEDURES
Stopping the Mixer (Gasoline Engine)
1. Place the

belt slip lever

in the

start/stop

position
(Figure 20).
2. Push the main
start/stop
switch (Figure 15) inward to
stop the engine.
3. Turn the fuel shut-off valve to the OFF position.
4. Disconnect the spark plug.
5. Clean mixer as referenced in the maintance section of
this manual.
NEVER disable or disconnect the start/stop switch. It is
provided for operator safety.

Serious Injury

may result if
it is disabled, disconnected or improperly maintained.
DANGERDANGER
DANGERDANGER
DANGER
It is recommended that the mixer's

Start/Stop switch

be used to stop
the engine after every use.
Doing this will verify that the switch is working properly and
presents no danger to the operator.
NOTE
DO NOT Disconnect
the Start/Stop Switch
Stopping the Mixer (Electric Motor)
1. Place the electric motor's

ON/OFF

switch (Figure 7) in
the OFF position.
2. Disconnect the electric motor's extension cord from its
power source.
3. Clean mixer as referenced in the maintance section of
this manual.