operation
3.To turn back the lamp to its original brightness, press the dimmer switch again. The LED will turn off.
4.Tor turn off the lamp while keeping the balloon inflated, press and hold the dimmer switch for three seconds. The LED will light red.
5.Zip up the bottom of the balloon completely after use of the dimmer switch.
NOTICE
To turn on lamp again, after it was turned off with the dimmer switch, turn off the Power ON/OFF switch.Wait three to five minutes then turn the ON/OFF switch back on. The lamp will now light back to 100% brightness.
NOTICE
If the power cable is accidentally unplugged from the power source, wait three to five minutes before reconnecting the power. This will allow time for the fan to reset and ensure balloon will inflate properly when power is reconnected.
SHUTDOWN
1.Turn off the power switch of the generator.
2.Turn off the Power ON/OFF switch.The balloon should start to deflate and the lamp will turn off.
3.Disconnect the AC power cable from the generator.
STORAGE
Before storing the GBC Lighting System, perform the following steps.
NOTICE
Allow about 15 to 20 minutes for the lamp to cool down before storing the GBC. The possibility exists of the balloon getting burned if it touches a hot lamp.
1.Disconnect the lamp connector from the AC power cable.
2.Make sure the mast is completely lowered as described in LOWERING THE MAST section.
3.Unhook the AC power cable from the eyelet at the bottom of the balloon.
4.Lock the buckle to secure the balloon together.
5.Unzip the zipper on the protective cover and pull down cover over the balloon/lamp assembly.
6.Attach velcro tabs.
7.Loosen the
8.Release the lever on the mast holder and pull out the mast.
9.Stow the three outriggers as detailed in the STOWING OUTRIGGER section.
gbc lighting system • operation and parts manual
