operation
NOTICE
To turn lamp back on, unplug the power cable from the power source. Wait three to five minutes before reconnecting the power. Reconnect the power cable and the lamp should turn on and the balloon will inflate.
STORAGE
Before storing the GBC/GBCE Lighting System, perform the following steps.
NOTICE
Allow about 15 to 20 minutes for the lamp to cool down before storing the GBC/GBCE.The possibility exists of the balloon getting burned if it touches a hot lamp.
1.Disconnect the lamp connector from the AC power cable.
2.Make sure the mast is completely lowered as described in LOWERING THE MAST section.
3.Unhook the AC power cable from the eyelet at the bottom of the balloon.
4.Lock the buckle to secure the balloon together.
5.Unzip the zipper on the protective cover and pull down cover over the balloon/lamp assembly.
6.Place the AC power cable in the pocket inside the protective cover and attach velcro tabs.
7.Loosen the
8.Release the lever on the mast holder and pull out the mast.
9.Stow the three outriggers as detailed in the STOWING OUTRIGGER section.
gbc/GBCE lighting system • operation and parts manual — rev. #1 (03/25/14) — page 21
