Multiquip LT6D operation manual Major Components 2 Control Panel Side

components

	21	19
	17	20
	18	22
	23
13	16	16
14	15

Figure 4. Major Components 2 (Control Panel Side)

13.Tongue Jackstand — Use this jackstand to support the tongue when attaching the light tower to a towing vehicle.

14.Safety Chain — Always attach safety chains to the towing vehicle. NEVER tow the light tower with the safety chain unattached. Make sure safety chains are crossed when towing.

15.Chock Blocks — Place blocks (not included as part of the light tower package) under each trailer wheel to prevent rolling.

16.Tie-Down Points — Used to tie down light tower with straps or chains to allow even application of force to the front and rear of the equipment during transport.

17.Fuel Tank/Cap — Remove cap to add No. 2 diesel fuel. Fuel tank capacity is 34 gallons (103.6 liters).

18.Engine Status Module — Displays engine status via LEDs, water temperature, air filter, fuel, alternator, oil pressure, glow plugs. Insert ignition key, turn clockwise to start engine.

19.Control Panel — Contains the auxiliary output receptacles, engine hour meter, excitation capacitor and circuit breakers.

20.Manual Holder — Contains information regarding the light tower.

21.Panel Light — When the cabinet door is raised, the light will automatically turn on. When the cabinet door is closed, the light will turn off

22.Engine — 3-cylinder, water cooled, direct injection, 12 HP diesel engine.

23.Battery — The 12-volt DC battery (CA:550/ CCA:430) is shipped wet and is ready for use. Battery is shown here for clarity.

LT6D LIGHT TOWER • operation manual — rev. #0 (07/16/13) — page 21