setup

Light tower grounding

If additional grounding (ground rod) of the light tower is required, connect a suitable ground cable to the light tower ground lug as shown in Figure 15.

Outriggers and Support Stands

1.

Place light tower on secure level ground with chock

 

blocks (Figure 16) underneath each wheel to prevent

 

the light tower from rolling.

2.

Make sure both outriggers (Figure 16) are extended.

 

To extend the outriggers, pull the locking pin on the

 

outrigger and hold while sliding out the outrigger

CONNECT

GROUND

TO BLDG.

ROD

GROUND

FOR EARTH

 

GROUND

GROUND

CABLE

8FT. MINIMUM

REFERENCE

NEC 250-83(C)

LIGHT TOWER GROUND LUG

assembly

PULL PIN TO

 

RELEASE

 

OUTRIGGER

 

PULL OUTRIGGER

 

TO EXTEND

 

OUTRIGGER

CHOCK BLOCK

ROTATE

 

JACKSTAND

 

TO PLACE

 

IN SUPPORT

 

POSITION

 

JACKSTAND

 

Figure 16. Deploying Outriggers

Figure 15. Grounding

3.As soon as the pin clears the travel position hole, release it and continue sliding out the outrigger. The pin must snap into the outrigger locking hole in the extended position.

4.After extending all outriggers, rotate all trailer jackstands into the foot down position, then turn the crank handle on the jackstands clockwise to lower it and level the light tower.

5.Check behind the light tower and make sure all personnel and objects are clear of the mast.

LT6D LIGHT TOWER • operation manual — rev. #0 (07/16/13) — page 31

Page 31
Image 31
Multiquip LT6D operation manual Light tower grounding, Outriggers and Support Stands, Light tower from rolling