PAGE 20 —MIX N' GO MIXER — OPERATION AND PARTS MANUAL — REV. #3 (09/20/11)
6. Tip mixer onto mouth as shown in Figure 10, and insert
support stand into frame swivel point.
9. Before attempting to lift mixer, locate the frame locking clip.
Attach the locking clip as shown in Figure 12. This will prevent
the mixing drum from moving when the mixer is positioned
in an upright position.
Figure 12. Frame Locking Clip
Figure 10. Attaching Support Stand
10. DO NOT tilt the mixer on a wet, smooth or slippery surface.
Figure 13. Slippery or Wet Surfaces
11. Once the stand has been assembled, and the locking clip has
been secured, begin tilting the mixer to an upright position.
Remember

always

tilt from the front of the mixer as shown
in Figure 14.
MIX N' GO MIXER — ASSEMBLY INSTRUCTIONS
7. Remove both wheels and wheel retainers from the packing
container.
8. Place one wheel on each side of the mixer's axle as shown
in Figure 11. Position wheel retainer over axle to secure
wheel in place. Use a rubber mallet when striking wheel
retainer.
Figure 11. Wheels and Wheel Retainers
Figure 14. Tilting Mixer to Upright Position