MDR-9D — HATZ 1D81Z ENGINE COMPONENTS
Figure 7. HATZ 1D81Z Engine Components
ENGINE COMPONENTS
Figure 7 illustrates the location of the major engine components of the machine. Each component is described below:
1. Fuel Filler Cap – Remove this cap to add diesel fuel to the fuel tank. Make sure cap is tighten securely. DO NOT over fill.
DANGER
Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the
engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.
2. | FuelTank – Diesel engine holds 5.8 quarts of diesel fuel. | |
3. | Air Cleaner – Prevents dirt and other debris from entering | |
| the fuel system. Remove | |
| cannister to gain access to filter element. | |
|
| Operating the engine without |
|
| an air filter, with a damaged air |
| NOTE | filter, or a filter in need of |
|
| replacement will allow dirt to |
enter the engine, causing rapid engine wear.
4. Muffler – Used to reduce noise and emissions.
WARNING
Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER
operate the engine with the muffler removed.
7. Oil Filler Cap/Dipstick – Remove this cap to add oil to the oil tank. Use dipstick to check oil level.
8.Oil Drain Plug – Unscrew plug to drain oil from engine crankcase. Dispose of oil in a safe manner.
9. Decompression Lever – Press down before starting engine.To prevent damage to the engine, DO NOT use for any other purpose.
10. Fuel Filter – Controls the flow of diesel fuel to the carburetor. Must be in the ON position when starting and running the engine.
11. Oil Filter – filters oil for contaminates.Replace as necessary.
12.Starting Handle Guide Sleeve – Insert starting handle into the guide sleeve and turn to crank start engine.
