Multiquip manual MDR-9DYE Inspection, Before Starting, Checking Fuel, Checking Engine OIL Level

CAUTION :

Never operate the vibratory roller in a confined area or enclosed structure that does not provide ample free flow of air.

ALWAYS wear approved eye and hearing protection before operating the vibratory roller.

BEFORE STARTING

1.Read safety instructions at the beginning of manual.

MDR-9DYE — INSPECTION

3.If the oil level is low, fill to the edge of the oil filler hole with the recommended oil type (Table 4). Maximum oil capacity is 1.6 quarts (1.1 liters).

TABLE 4. OIL TYPE

Season	Temperature	Oil Type
Summer	25°C or Higher	SAE 10W-30
Spring/Fall	25°C~10°C	SAE 10W-30/20
Winter	0°C or Lower	SAE 10W-10

2.Familiarize yourself with the operating and control elements of the machine and

the working environment. This includes obstacles in the working area, bearing capacity of the ground and the necessary safety provisions.

3.Checktheairfilterfordirtanddust.Iftheairfilterisdirty, replace air filter with a new one as required.

4.Check fastening nuts and bolts for tightness. Loose threads may cause damage to the machine when vibrating.

Explosive Fuel

DANGER

Diesel fuel is highly flammable and can be dangerousifmishandled.DONOTsmokewhile refueling.DO NOT attempt to refuel the vibra- tory roller if the engine is hot! or running.

CHECKING FUEL

5.	Understand the geographical features and regulations of	1.	Remove the fuel cap located on top of fuel tank.
	the job site.	2.	Visuallyinspecttoseeiffuellevelislow. Iffuelislow,replenish
6.	Clean the vibratory roller, removing dirt and dust, particularly,
	the bottom of the plate, engine cooling air inlet.		with diesel fuel (Figure 9).

CHECKING ENGINE OIL LEVEL

1.Make sure that the machine is situated in a flat surface so that level measurements will be accurate.

2.Pull out the dipstick from the oil tank (Figure 8).

CAUTION :

DO NOT overfill oil tank. This could cause oil leaks and sluggish operation. Clean cap and surrounding area before opening to prevent dirt from entering tank.

3.Whenrefueling,besuretouseastrainerforfiltration.DONOT top-off fuel.Wipe up any spilled fuel.

Figure 9. Refueling

DANGER

Fuel spillage on a hot engine can case a fire or explosion. If fuel spillage occurs, wipe up the spilled fuel completely to prevent fire hazards. NEVER! smoke around or near the roller.

Figure 8. Oil Dipstick

PAGE 18 — MQ-MIKASA MDR-9DYE VIBRATORY ROLLER — PARTS & OPERATION MANUAL — REV. #0 (12/19/03)