BASIC ENGINE

Figure 2. Engine Controls and Components

INITIAL SERVICING

The engine (Figure 2) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers Engine manual for instructions & details of operation and servicing.

1. Secondary Air Cleaner – Prevents dirt and other debris from entering the fuel system. Remove wing-nut on top of air filter cannister to gain access to filter element.

2. Choke Lever Used when starting the engine. Normally used in cold weather conditions. In cold weather turn the choke lever to the fully closed position, in warm weather set choke lever half way or completely open.

3. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.02 - 0.03 inch (0.6 - 0.7 mm). Clean spark plug once a week.

5.

Recoil Starter (pull rope) – Manual-starting method. Pull

 

the starter grip until resistance is felt, then pull briskly and

 

smoothly.

6.

Muffler – Used to reduce noise and emissions.

CAUTION - Burn Hazard

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.

4. Engine ON/OFF Switch – Controls the starting and stopping of the engine. Switch must be in the "ON" position when starting the engine.

7.

Dipstick/Oil Filler Cap – Remove this cap to determine if

 

the engine oil is low. Add oil through this filler port as

 

recommended in Table 3.

8.

Oil Drain Plug – Remove this plug to remove oil from the

 

engine's crankcase.

NOTE

Operating the engine without an air filter, with a damaged air filter, or a filter in need of replacement will allow dirt to enter the engine,

MT55F RAMMER — OPERATION AND PARTS MANUAL — REV. #5 (01/06/12) — PAGE 13

Page 13
Image 13
Multiquip MT55F manual Basic Engine, Initial Servicing