Multiquip MT55F manual Nameplate and Decals, To start, switch must be in the on position

5

NOTICE

CLEAN THE ELEMENT WITH KEROSENE WHEN DIRTY. AFTER THE CLEANING, LUBRICATE IT MIXED OIL (KEROSENE 2~4: ENGINE OIL 1), SQUEEZE OUT THE OIL, AND REPLACE IT. AND CLEAN IT MORE

OFTEN WHEN OPERATING IN DUSTY CONDITIONS. NP-831 J

NAMEPLATE AND DECALS

14

3800 ~ 4100 RPM

NPA-957 J

2

13

To start, switch must be in the “ON” position

NPA 293

11 12

READ OWNER’S SERVICE MANUAL BEFORE OPERATING OR

SERVICING THIS MACHINE.

ALWAYS KEEP UNAUTHORIZED, INEXPERIENCED,

UNTRAINED PEOPLE AWAY FROM THIS MACHINE.

MAKE SURE ALL SAFETY DEVICES ARE OPERATIONAL

BEFORE THIS MACHINE IS STARTED. MAKE SURE ENGINE

IS TURNED OFF AND SPARK PLUG WIRE DISCONNECTED

BEFORE SERVICING THE MACHINE OR COMING IN

CONTACT WITH ANY MOVING PART. IF EQUIPMENT IS

POWERED BY AN ELECTRIC MOTOR DISCONNECT

ELECTRICAL PLUG.

NEVER LEAVE MACHINE UNATTENDED WHEN OPERATING.

ALWAYS STOP ENGINE AND ALLOW ENGINE TO COOL

BEFORE ADDING FUEL OR OIL.

NPA-329 J	3
1

GASOLINE ONLYDCL205

	4
CAUTION	OPERATION
Prior to each operation check	To START engine:
Check all nuts and bolts for tightness.	Open fuel filter valve and close choke lever on carburetor.
Check oil levels in both the engine and the lower unit.	Place starter switch to “ON” and pull start rope.
Keep machine at the upright operating position to check.	When engine starts, open the choke lever and warm up the
1. Lower unit assembly-Check sight glass for proper level.	engine for 4-5 minutes before operation.
2. Engine-Fill to the lower outer rim.		To STOP engine:
	Move the throttle lever quickly from “ON” to “OFF” position.
NPA-975 J	Then move starter switch to “OFF” and close the fuel filtervalve.

	Oil
	öl
	I’ huile
	SAE30
NPA-961 E	7~9 cc

10

When you stop the engine, be sure to close the fuel cock

NPA-399 J

Mikasa

OHV

9

CAUTION

ATTENZIONE

ATENÇAÕ

PRECAUCION

*Read operator’s manual carefully before use.

*Libre le manual attentivement avant utillsation.

*Bitte lesen Sie vor inbetriebnahme der Maschine de Bedienungsanleitung sogfältig durch.

*Prima dell’ uso leggere attentamente il manuale.

*Lee com atenÇão o manual de instruÇões antes de usar.

*Leer detenidamente el mamual de instrucciones antes de usar la maquina.

NPA-769 J

NPA-910 J

8

Mikasa		6
	7	CLEANING ELEMENT:	NPA-963 J
MT-
		Remove the element from the pre-cleaner
		Clean the element with solvent
		Apply SAE30 motor oil with 7~9 cc, and
55F
		squeeze out excess oil before re-installing.

PRIMARY AIRFILTER CHECK DAILY DCL207

NAMEPLATE

PAGE 24 — MT55F RAMMER — OPERATION AND PARTS MANUAL — REV. #5 (01/06/12)